Mettre en évidence:
Anjeka 6272 polymer dispersant for printing inks and adhesives
GENERAL DESCRIPTION
Anjeka-6272 is a polymer dispersant for aqueous coating systems, printing inks and adhesives. It is a standard additive for resin-free pigment concentrates. It is mainly used for organic pigments and carbon blacks, and has good viscosity reduction and color spreading properties.
PRODUCT DATA
Typical Physical Chemistry Data:
The data given on this data sheet are typical values and are not technical specifications of the product.
| Chemical composition: |
nonionic block copolymer |
| Acid value (mg KOH/g) |
1-15 |
| Amine value (mg KOH/g) |
1-15 |
| Density g/cm³ (23℃) |
1.00-1.20 |
| Viscosity cps (25℃) |
300-3000
|
| Appearance: |
Light yellow liquid |
| Active ingredient (%) |
80 |
| Solvent |
Water |
STORAGE and TRANSPORT
When stored or transported at temperatures below 15°C, delamination or turbidity may occur. Heat to 40°C and stir before use.
Storage time is not recommended to exceed 12 months.
APPLICATION GUIDELINES
Water-based inks, coatings, water-based general-purpose color pastes.
Properties and advantages.
This additive causes pigment deflocculation through spatial stabilization. Due to the small particle size of the deflocculated pigment, it is possible to obtain a high gloss, as well as an increase in color strength. In addition, the transparency of transparent pigments and the hiding power of opaque pigments are improved. Due to the reduced viscosity, the flow properties are improved and the pigment content can be increased.
This additive is particularly suitable for the production of stable, resin-free pigment concentrates with pigment contents of 30-70%. These pigment concentrates can be used for paint mixing with standard aqueous bases.
GUIDELINES
Industrial coatings ●
Automotive coatings ●
Leather coatings ●
Anti-corrosion coating systems ●
Waterborne Adhesives ●
Water-based ink ●
●--Special recommendation; ○--Recommendation
This additive is also recommended for the production of stabilized resin-free pigment concentrates for the preparation of waterborne coatings with no floating/blooming colors.
RECOMMENDED LEVELS
Additive dosage (in purchased form) is based on pigment:
Inorganic pigments: 2% - 10%
Organic pigments: 10%-80
Carbon black: 10%-100
The above data are empirical and the optimum dosage should be determined through a series of tests.
INCORPORATION AND PROCESSING INSTRUCTIOS
It can be added before grinding, and has good general effect in water-soluble, aqueous dispersion and emulsion system.
PACKAGING
-25kg iron drum with inner coating
-180kg ring plastic drum
Votre message doit contenir entre 20 et 3 000 caractères!
